Setting Up the BikeErg

The BikeErg provides a range of settings for the saddle and handlebars so that you can find the position that is most comfortable and effective for you Here are instructions and recommendations to get you started

Line drawing shows that the ratchet lever is on the back of the seat post, where the post meets the BikeErg body. Push down on that first, then push down or pull up on the seat to adjust height.

How to Adjust the Saddle

To lower the saddle: Release the ratchet by pressing down on the lever (1, right). Press the saddle down to the desired position (2, right). Release the lever to lock into position.
To raise the saddle: Pull upwards to desired height. Confirm that the ratchet has locked into position before use.
The fit of the seat post into the back leg has been adjusted at the factory to allow for easy movement.
The frame geometry is designed so that raising the saddle also moves the rider back, maintaining the correct relationship to the pedals. For general use, the saddle placement on top of the seat post will not need adjustment. For fine tuning the horizontal position and saddle angle, adjustments can be made using a 1/2”or 13mm wrench (not included).

Recommendations for Saddle Position

While riding: With the ball of your foot on the pedal, your leg should maintain a slight bend at maximum extension.
While sitting on the saddle: Determine a comfortable seat height by placing your heel on the down pedal with your leg straight. If you are stretching to reach the pedal, lower the saddle. If you cannot straighten your leg, raise the saddle.

The handlebar height adjustment knob is at the base of the handlebar post on the right-hand side. Loosen that first, then push down on the ratchet lever. The ratchet lever is also at the base of the handlebar post, on the side that faces toward the BikeErg seat. The handlebar front/back adjustment knob is located along the horizontal arm that holds the monitor.

How to Adjust the Handlebars

To lower the handlebars: Loosen the adjustment knob (1, right). Release the ratchet by pressing down on the lever (2, right). Push the handlebars down to the desired position. Release the lever to lock it into position and retighten the adjustment knob.
To raise the handlebars: Loosen the adjustment knob (1, right) and pull upwards to desired height. Confirm that the ratchet has locked into position and retighten the adjustment knob.
To adjust the handlebar reach position: Loosen the adjustment knob (3, right) and slide handlebars forward or back as desired. Retighten the adjustment knob.

Customize

The connection points between the BikeErg and pedals, saddle, and handlebars are standard to most bicycle components, allowing the use of owner-supplied components, if desired. When substituting components, be sure to use parts that are recommended for exercise bikes. Warning: Third party pedals and handlebars are often not suitable for the forces on stationary exercise bikes. Note: Warranty does not cover use of the BikeErg with parts or accessories from third parties.